image source: structuretech1.com
Overflowing of water heaters is caused in part by the fact that they generate heat and pressure during their operation. The unit also consist of an open flame or in some units a high voltage electrode. This, when it goes wrong can be the cause of concerns for the personal safety of the home owners. To lessen the possibility for reasons why the water heater overflows the assistance of the highly experienced plumbing crews from You Plumbing is available.
Some precautions to reduce the possibility of overflowing are reduce by troubleshooting for the cause of the overflow. When troubleshooting the gas valve must be turned off and if electrically supplied the power must be switched off. Turn off the cold water supply to prevent further water from entering the unit. Online plumbing supplies Australia
See if the leak can be detected visually. If the unit is leaking from the valve on the top side of the unit, then we know that the problem is caused by the pressure relief valve. It happens often that mineral deposits over time can be the cause of the leak. It could also be caused by high temperatures and pressure. The valve must be replaced.
Should the leak be detected from the cold or hot water pipes then rust or corrosion may bethe cause. Replace the pipes.
Water leaking from the area around the drain valve could be caused by a defective washer or mineral deposits from the water source.
Water leaking from a water heater is normally visible directly under the unit and may cause a sound when touching the hot unit. This could sound quite dangerous and immediate action is required.
Using the team from You Plumbing with their 24/7 service in Sydney can eliminate the problem fast and cost effectively.